Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Electrolux EWS 1050
Summary of Contents for Electrolux EWS 1050
- Page 2 Problem Possible cause The program is still running and the drum is turning. The door can not open : The door lock has not yet released. The water level is above the bottom edge of the door. The machine is heating the water, and the water temperature is higher than 55 The door can only be opened when the relevant light has gone out.
-
Page 3: Something Not Working
Something not working? Problems which you can resolve yourself During machine operation it is possible that one of the End light starts to flash: E10:problem with the water supply 15 - 17 E20: problem with the water draining E40:door open Once the problem has been eliminated, press the START/PAUSE button to restart the programme. -
Page 4: Emergency Emptying Out
6. Emergency emptying out Remove any objects from the pump impeller by rotating it. If the water is not discharged , proceed as follows to empty out the machine: Pull out the plug from the power socket; Close the water tap; If necessary, wait until the water has cooled down;... -
Page 5: Door Seal
Maintenance Detergent can also accumulate inside the drawer recess: clean it with an old toothbrush. Refit the drawer after cleaning. 1. Door seal Check from time to time the door seal and eliminate eventual possible objects that could be trapped in the fold. -
Page 6: Programme Table
Programme table Type of laundry Programme/ Description of Available options Max load and symbols on temperature programme labels Cottons Wash at 60-95 Spin speed white cotton: Rinse hold 60-95 three rinses Night cycle e.g. : work clothes, long spin Economy sheet,household Super Quick wash linen, table cloth... - Page 7 12. How to cancel a programme dur- If you had selected the RINSE HOLDor NIGHT CYLCE option , the light of the START/PAUSE button goes out, ing its cycle 90cm the zero on the display begins to flash, the door is To cancel a programme that is being carried out, first locked and RINSE HOLD or NIGHT CYCLE light re- pause the washing machine by pressing theSTART/...
- Page 8 Important! delay. The selected delay time value (up to 23 hours) Every programme has its limited temperature in order will appear on the display for 3 seconds, then the to preventing laundry from being spoiled,so it’s normal duration of the programme will appear again. that some temperature can not be chosed.
-
Page 9: Operating Sequence
Operating sequence. Before washing your first load of laundry we recom- mend that you run a cotton cycle at 60 with the machine empty, in order to remove any manufac- turing residue from the drum and tub. 1. Place the laundry in drum 5. -
Page 10: International Wash Code Symbols
International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash Max. wash Max. wash Max. wash Max. wash temperature temperature temperature temperature 95 C 60 C 40 C 30 C Do not... -
Page 11: Quantity Of Detergent To Be Used
Ink: depending on the type of ink, moisten the fabric Quantity of detergent to be used first with acetone ( ), then with acetic acid; treat any The type and quantity of detergent will depend on the residual marks on white fabrics with bleach and then type of fabric, load size, degree of soiling and hard- rinse thoroughly. -
Page 12: Laundry Weight
Laundry weight Washing hints The following weights are indicative: Sorting the laundry Bathrobe 1200g Napkin 100g Follow the wash code symbols on each garment label Quilt cover 700g and the manufacture’s washing instructions. Sheet 500g Sort the laundry as follows: Pillow case 200g Whites, coloureds , synthetics, delicates, woolens. - Page 13 In this case,both the drain and the spin (at the speed The time value shown on the display will decrease by provided for the selected type of fabric) will be one unit every hour till the first 2 hours, and then it performed.
- Page 14 The washing machine has completed the An alarm code indicates a fault in the machine op- programme: this is indicated by a blinking zero. eration . The zero will reappear when you switch the washing machine on, unless the previous programme has been erased by means of the SKIP RESET button.
- Page 15 drain and spin: PREWASH: select this option if you wish your laun- press the FABRICS button to select the type of dry to be prewashed before the main wash (not fabric previously washed, eventually reduce the spin available for WOOL / HAND WASH and silk speed, and then press the SKIP RESET button twice, programme).
-
Page 16: Control Panel Description
Control panel description 10 11 1. ON/OFF button Sterilization 95 option can hold high temperature for Press this button to switch the washing machine on. 10 minutes, in order to eliminate microphyte from the Press the ON/OFF button again to switch the machine laundry By selecting position COLD the machine will wash with o f f . -
Page 17: Your New Washing Machine
Your new washing machine This new washing machine incorporates all the latest functions and wash technology from Europe and is built according to the highest manufacturing and quality standards, thus giving you optimal wash performance, lowest energy & water consumption and specially designed fabric care options: SANITARY WASH 95 a special wash cycle that heats up water to high temperature and maintains it for more than 10 minutes will destroy most of all bacteria, thus ensuring healthy wash for you and your family. -
Page 18: Water Drainage
When connect the waving junctures with inlet valve, Directly into a drain pipe at a height of not less please aviod leakage and loose for joint deviation of than 60cm and not more than 90cm.The end of the screw thread. drain hose must be always ventilated and the inside Pay attention to avoid the damage for over-bending. -
Page 19: Positioning And Levelling
Installation Plug the open holes with the plugs, which you will find in the plastic envelope containing the instruc- tion booklet. Unpacking All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that th- ey can be refitted if the machine ever has to betrantra- nsported again. -
Page 20: Tips For Environmental Protection
Disposal Packaging materials The materials marked with the symbol are recy- clable. polyethylene polystyrene When the appliance is to be scrapped, cut off the polypropylene electrical supply cable and destroy the plug with the This means that they can be recycled by disposing of remaining cable. - Page 21 Warnings Installation Always unplug the appliance and shut the water tap after use. All internal packing must be removed before using the appliance. Serious damage may be caused to the machine or adjacent furniture if the protective General safety transit devices are not removed or are not com- Repairs to the machine must be carried out only by pletely removed.
-
Page 22: Table Of Contents
Programme table Contents Maintenance Warnings - E10 Door seal - E20 Bodywork Disposal - E40 Detergent dispenser drawer Tips for environmental protection Drain pump Water inlet filter Technical specifications Emergency emptying out E 4 0 Frost precautions Installation Something not working? 21-22 Unpacking E 1 0... - Page 23 Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, Check that it is not damaged.