Electrolux EWS 1050 Instruction Manual page 14

The washing machine has completed the
programme: this is indicated by a blinking zero.
The zero will reappear when you switch the washing
machine on, unless the previous programme has
been erased by means of the SKIP RESET button.
Important!
The first time you use the washing machine, when
you switch it on, it may display a blinking zero and
give an audible warning signal. This is due to the fact
that the washing machine has performed a washing
cycle during the manufacturer's inspection tests, and
this cycle has not been erased after its completion.
Delay start, a time value indicated in hours and
selected by means of the relevant button. The delay
time is displayed for 3 seconds, then the duration of
the selected programme reappears. After you have
pressed the START/PAUSE button, the countdown
begins, and the delay time value decreases by one
unit every hour till the first 2 hours, and then it
decreases by one unit every 30 minutes. You can
delay the start of every programme selecting the
DELAY START button. The delay time is indicated
first by 30-60-90 minutes, and then by hours up to
23 hours.
An incorrect option selection has been made:
this is indicated by the message Err when a function
incompatible with the current programme is selected.
The incorrect selection is also indicated by an au-
dible warning signal.
An alarm code indicates a fault in the machine op-
eration .
9. START/PAUSE button
This button has two functions:
Start: after you have selected the desired programme
and options, press this button to start the washing
machine. The light above the button will stop flash-
ing and remain lit. If you have selected a delay time
by means of the relevant button, the countdown will
begin and will be shown on the display.
Pause: when you press this button again, the
programme in progress is interrupted. (you can add
missing clothes).The light above the button will start
flashing. To restart the programme, press the button
again.
Important!
You must set the washing machine to PAUSE before
you make any change in the programme in progress.
10. SKIP/ RESET button
At the end of a programme, you must press this but-
ton once or repeatedly, in order to clear the contents
of the memory (the display will show three blinking
dashes); otherwise, the next time you switch the wash-
ing machine on, the blinking zero will reappear and the
audible warning signals relevant to the end of the pre-
vious cycle will be given. You can also press the SKIP
RESET button to exclude one or several phases of the
programme which is running, as indicated below: - set
the washing machine to PAUSE by pressing the START/
PAUSE button (the relevant light will flash);
-
press the SKIP RESET button once or several times,
until the required phase(s) is(are) cancelled.
Example:
10 13