Electrolux EWS 1050 Instruction Manual page 13

95
60
30 -40
12
In this case,both the drain and the spin (at the speed
provided for the selected type of fabric) will be
performed. This button allows you also to select spe-
cial programmes, such as RINSES, SPIN and DRAIN.
If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
-
depress SKIP RESET once or repeatidly to cancel
the previously performed programme (three blinking
1200 g
dashes will appear on the display);
-
100 g select the type of fabric by means of the relevant
button;
700 g
- select the special programme:
500 g
RINSES
200 g
Depress SKIP RESET once, the pilot light WASH goes
250 g
out.
SPIN
200 g
Depress SKIP RESET twice, the pilot lights WASH
100 g
and RINSES go out.
200 g
DRAIN
Depress SKIP RESET three times, the pilot lights
100 g
WASH, RINSES and SPIN go out and only the pilot
600 g
light DRAIN remains lit.
200 g
Example:
500 g
100 g
100 g
In this case the machine will perform the rinses and
spin.
If the machine is switched off:
-
depress ON/OFF button to switch it on;
- select the type of fabric by means of the relevant
button;
-
select the special programme as previously
described.
11. DELAY START button
This button makes it possible to delay the starting of
the programme by up to 23 hours.For example, if you
want to take advantage of low energy price rates dur-
ing nighttime. The delay you have selected is shown
on the display for about 3 seconds; afterwards, the
duration of the programme reappears. You must se-
lect this option after you have set the programme and
before you press the START/PAUSE button.
The time value shown on the display will decrease by
one unit every hour till the first 2 hours, and then it
decreases by one unit every 30 minutes.
You can change the delay time at any moment,
before you press the START/PAUSE button. If you
have already pressed the START/PAUSE button, and
you wish cancel the delay time, proceed as follows:
set the washing machine to PAUSE by pressing the
START/PAUSE button;
press the DELAY START button twice, to erase the
delay time. The display will indicate "0".
press the START/PAUSE button again.
Important!
The door will be locked throughout the delay time. If
you need to open the door, you must first set the
washing machine to PAUSE by pressing the START/
PAUSE button. After you have closed the door, press
the START/PAUSE button again.
12. Programme phase indicator lights
When you select a programme, the lights relevant to
the phases that form the programme light up.
After you have started the programme, only the light
relevant to the phase that is currently being carried out
will remain lit.
11