Page 1
NOTE: Please read all instructions carefully before using this product Table of Contents MARCY Safety Notice MWB-544 BENCH Hardware Identifier Assembly Instruction Exploded Diagram Parts List Warranty Ordering Parts Model MWB-544 Retain This Manual for Reference March 5, 2005 OWNER'S MANUAL IMPEX INC.
PARTS LIST... WARRANTY... ORDERING PARTS... BEFORE YOU BEGIN Thank you for selecting the MARCY MWB-544 BENCH by IMPEX INC. For your safety and benefit, read this manual carefully before using the machine. As a manufacturer, we are committed to provide you complete customer satisfaction.
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC. ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
ASSEMBLY INSTRUCTION Tools required to assembly the machine: Two Adjustable Wrenches STEP 1 (SEE Diagram 1) A.) Connect the two Rear Upright Beams (#1) by a Cross Brace (#25) in the Mid-span. Fasten them by two M10x 2 3/8” Bolts (#14), four (#12), and two M10 Aircraft Nuts (#15) on each side of the Cross Brace.
Page 6
STEP 2 (SEE DIAGRAM 2) A.) Connect the Front Stabilizer (#49) to the Main Seat Support (#32) and secure them with two M10 x 1” Bolts (#42), four (#15). DO NOT tighten the nuts and bolts yet. B.) Connect the Main Seat Support (#32) to the Cross Brace (#25) and secure it with two M10 x 2 3/8”...
Page 7
STEP 3 (SEE DIAGRAM 3) A.) Attach a 7/8” Washer (#13) onto a M10 x 4 ½” Bolt (#24). Insert the Bolt through the Butterfly (#22). Place a M10 Regular Nut onto the Bolt. Then insert the Bolt through the hole on the Rear Upright Beam (#1). Secure the Bolt with a Knob (#11) behind the Upright Beam.
Page 8
STEP 4 (SEE DIAGRAM 4) A.) Attach the hole-side of the Backrest Supports (#28) onto both ends of the Pivot on the Main Seat Support (#32). The other side rest against the Backrest Adjustment Bar (#10). B.) Place the Backrest Board (#33) onto the Backrest Support (#28). Fasten it with four M6 x 1 3/8”...
PARTS LIST KEY NO. DESCRIPTION Rear Upright Beam Right Bar Catch Curl Bar Spring Clip 1” Round End Cap Left Bar Catch Bar Catch Panel 3/4” Flat End Cap 1 ½” Square End Cap Backrest Adjustment Bar Knob Bracket 7/8” Washer M10 x 2 3/8”...
IMPEX Customer Service Department at 1-800-999-8899. All freights on products returned to IMPEX must be prepaid by the customer. This warranty does not extend to any product or damage to a product caused by or attributable to freight damage, abuse, misuse, improper or abnormal usage or repairs not provided by a IMPEX authorized service center or for products used for commercial or rental purposes.