Impex MARCY MWB 716 Owner's Manual page 8

STEP 4 (See Diagram 4)
A.) Attach the Leg Developer (#15) to the Front Stabilizer (#6). Secure it with one Axle
(#19), two M10 x 5/8" Allen Bolts (#39), and two Ø ¾" Washers (#43).
B.) Insert one Foam Tube (#18) halfway through the hole on the Front Stabilizer. Insert two
Foam Tubes halfway through the holes on the Leg Developer.
C.) Push six Foam Rolls (#22) onto the Foam Tubes from both ends. Plug six Foam Roll
End Caps (#29) into the ends.
D.) Attach the Curl Bar (#16) to the bracket on the Leg Developer. Secure it with a 3" L-
shaped Pin (#34). Attach an Olympic Sleeve (#32) onto the weight post on the Leg
Developer. Attach a Spring Clip (#21) to the Sleeve. NOTE: When using the decline
position to do Ab exercises, place at least 30 lbs of weights on the post to hold down the
Leg Developer.
E.) When using Leg Developer, remove the Arm Curl Stand and the Curl Bar.
7
DIAGRAM 4