Installing The Touch Pad And Finger Print Board - Toshiba Qosmio X300 Maintenance Manual

Error! Style not defined. Error! Style not defined.

Installing the Touch Pad and Finger Print Board

Install the touch pad and Finger Print board according to the following procedures and Figure
4-21.
1. Seat the finger print board, touch pad, and touch pad bracket in the correct position and
secure with two M2.5x4 screws
2. Connect the three touch pad flat cables to the touch pad board.
3. Put in place the two flat cables in the wire guide.
Qosmio X300 Maintenance Manual
4 Replacement Procedures
4-39