Impex Marcy Diamond Elite MD-PWR-20 Owner's Manual page 13

STEP 6 (See Diagram 6)
A.) Do not tighten Nuts and Bolts until instructed to do so.
B.) Align the bracket on the Backrest Adjustment Support (#32) in between the two Backrest Supports
(#35). Secure it with four M8 x 1 5/8" Allen Bolts (#81), eight Ø 5/8" Washers (#85), and four M8
Aircraft Nuts (#87).
C.) Insert the Backrest Adjustment Support into the opening on the Main Seat Support (#18). Press or
step down on the Backrest Adjustment Lever (#36) to allow the Support to go through.
D.) Attach the bottom side-holes on the two Backrest Support to the pivot on the Main Seat Support.
Secure it with one M10 x 6 ½" Allen Bolt (#72), two Ø ¾" Washers (#84), and one M10 Aircraft Nut
(#86).
E.) Attach the Backrest Board (#29) to the Backrest Supports. Secure it with four M8 x 1 5/8" Allen
Bolts (#81) and Ø 5/8" Washers (#85).
F.) Attach the Seat Pad (#30) to Seat Bracket (#24). Secure it with four M8 x 1 5/8" Allen Bolts (#81)
and Ø 5/8" Washers (#85).
G.) Securely tighten all Nuts and Bolts.
H.) When adjusting the Backrest Board to an incline position, simply pull up the Board. When adjusting
the Board to a decline position, press or step down on the Backrest Adjustment Lever to disengage
the Lever to allow the Board to go down.
12
DIAGRAM 6