Control Panel; Dryer Components; Top Panel - GE Profile PTDS650EM Technical Service Manual

WARNING: Sharp edges may be exposed when
servicing the dryer. Use caution to avoid injury.
Wear Kevlar gloves or equivalent protection.
Caution: After any service, repair, or installation
of a new component, ensure all vapor shields are
properly installed.
Note: Combined Phillips-head/square-drive recess
screws are utilized throughout this appliance. Either
Phillips or square-drive screwdrivers can be used to
extract or install these screws.

Control Panel

It is necessary to remove the control panel from
the backguard and place it in the service position
to access the control board. The control panel is
attached to the dryer with 4 Phillips-head screws
and 3 lock tabs that protrude from the bottom.
Caution: To prevent damage to the control panel,
place a protective surface on the top panel.
To place the control panel in the service position:
1. Remove 4 screws from the rear of the control
panel.
2. Gently pull on each corner to unsnap the control
panel from the sides of the unit.
Unsnap

Dryer Components

3. Rotate the control panel forward approximately
1 inch, then slide it to the right to unlock the 3
bottom lock tabs.
4. Lift up the panel and place it facedown on the
protective surface.

Top Panel

The top panel is fastened at the front by 2 screws
and at the rear by 3 lock tabs that protrude from the
bottom of the control panel.
To remove the top panel:
1. Remove the control panel. (See
2. Remove 2 screws that secure the top panel to
the cabinet.
3. Pull the top cover toward you while lifting up the
front edge to release the side catches. Slide the
top cover to the left to release it from the 3 tabs.
– 19 –
Lock Tab (1 of 3)
Service Position
Control Panel
.)