Appendix A Solutions; Table A-1 Solutions - Honeywell HTR62 Installation And Operating Manual

Htrs mobile video system
Table of Contents

Advertisement

Solutions
If this happens ...
Power LED is off
No picture on monitor
VCR is not recording
VCR tape involuntarily ejects
Rev 1.01
This appendix provides solutions to common program and operation issues.
Table A-1
Solutions
Do this ...
Check the wiring to the battery. The red wire of the HTR62 power
harness should be connected to the positive battery terminal through a
3A fuse. The black wire of the HTR62 power harness should be
connected to the negative battery terminal.
Check the fuse. If the fuse is blown, determine the cause and rectify it
before replacing the fuse. Check for pinched or crossed wiring.
Ensure that the DB25 connector on the HTR62 wiring harness is
plugged into the VCR.
Ensure that the white wire of the HTR62 signal harness is connected to
the ignition switch and the ignition switch is on.
If the VCR powers up when you press the POWER button (temporary
power), the ignition switch connection may be faulty.
Start the vehicle engine to make sure the battery voltage is high enough
to power the HTR62; that is, more than 10 volts.
Ensure that the power, video, and audio connectors of the camera
harness are plugged into the HTR62 power, video in, and audio in jacks.
Make sure that the camera LED indicator is on.
Start the vehicle engine to make sure the battery voltage is high enough
to power the HTR62.
Ensure that the video tape is not write protected.
Start the vehicle engine to make sure the battery voltage is high enough
to power the HTR62.
Check to see if:
The tape is too old or worn; in either case the VCR cannot record to
the tape. We recommend that you do not use a tape more than 10
to 20 times, depending on how dusty or rough the roads may be
where the system is being used. The worse the operating
conditions, the more often the tapes should be recycled.
The temperature is too cold; that is, lower than the recommended
operating range of +41ºF to +104ºF (+5ºC to +40ºC). You can
program the built-in timers to delay recording 10 to 20 minutes after
the bus is first started to give the VCR a chance to warm up as the
bus warms up (see
Lines 5 and
6, page 20).
27
A
Document 900.0341
12/05

Advertisement

Table of Contents
loading

Table of Contents