Table of Contents
Advertisement
Control
Program mode function
STOP
Use this button to:
•
•
Note
SLOW (
)
AUDIO
A/V
TCOUNTER
A REPEAT
REC
SPEED
Programming the VCR
Rev 1.01
Table 3-1
Remote Control Button Functions
Enter Program mode. Press and hold
the button for three seconds to
display the Setup screen.
Exit Program mode. Press and hold
for three seconds. Your configuration
settings are saved when you exit
Program mode.
The VCR automatically exits
Program mode if no button is
pressed in 60 seconds.
The display parameters, date and time, speedometer calibration, and power control
settings must be programmed into the VCR. The alphanumeric information displays on
three lines at the top or bottom of the image on the screen (user selectable).
Note
The programmed settings are retained in the VCR even if the HTR62 is
disconnected from the vehicle battery.
To program the VCR:
1.
Unlock the access panel on the front of the VCR enclosure and remove the enclosure
cover.
2.
Plug an RCA cable into the VIDEO OUT jack in the front panel of the VCR. Plug the
other end into the VIDEO IN jack of a portable monitor.
HTR62 Installation and Operating Guide
Play mode function
Stops the current VCR operation or stops
image playback.
If the ignition trigger is on, the VCR
automatically starts recording.
Resumes normal playback speed.
Selects audio playback function.
Not currently available.
Displays tape timer
Not currently available.
Not currently available. You can change the
recording speed in Menu mode (see
and
6, page 20).
Not currently available.
15
Lines 5
Document 900.0341
12/05
Advertisement
Table of Contents
