Inserting A Tape In The Vcr; Starting Recording; Stopping Recording - Honeywell HTR62 Installation And Operating Manual

Inserting a Tape in the VCR

Starting Recording

Stopping Recording

Rev 1.01
To insert a tape in the VCR:
1. Unlock the access panel on the front of the VCR enclosure.
2. If the vehicle ignition is off, press POWER on the front panel of the VCR. The VCR
must be powered to accept the tape.
3. Insert the video tape into the slot until the VCR pulls the tape inside. Do not force the
tape to avoid damaging the VCR.
Turn the vehicle ignition on. The VCR automatically starts recording after approximately 10
seconds, subject to Record Delay and Timer settings.
You can also start recording by pressing the REC button on the remote control.
Note Unless the VCR is in temporary power mode, the vehicle engine must be
running to ensure that the battery voltage is high enough to start the HTR62
system.
Turn the ignition off.
If the Delayed-off time (see
minutes, the VCR switches off.
If the Delayed-off time has been programmed for 01 to 20 minutes, the VCR remains
on for the specified time after the vehicle ignition is switched off.
You can also stop recording by pressing the STOP button on the remote control or the
STOP/EJECT button on the front panel of the VCR.
Note The VCR begins recording again after one minute of no button activity if the
ignition trigger is still active.
HTR62 Installation and Operating Guide
Lines 5 and 6, page 20) has been programmed to 00
25 Document 900.0341
12/05