Page 1
TE 3000-AVR Operating instructions Mode d’emploi Manual de instrucciones Manual de instruções Printed: 08.07.2013 | Doc-Nr: PUB / 5070853 / 000 / 03...
Page 2
This Product is Certified Ce produit est certifié Este producto esta certificado Este produto está certificado Printed: 08.07.2013 | Doc-Nr: PUB / 5070853 / 000 / 03...
ORIGINAL OPERATING INSTRUCTIONS TE 3000‑AVR breaker 1 These numbers refer to the corresponding illustra- It is essential that the operating instructions tions. The illustrations can be found on the fold-out cover are read before the power tool is operated for pages.
Make a note of this data in your operating instructions and always refer to it when making an enquiry to your Hilti representative or service department. Wear eye Wear a hard...
Page 9
The power tool may be operated only when connected to a power supply providing a voltage and frequency in compliance with the information given on its type identification plate. To avoid the risk of injury, use only genuine Hilti accessories and insert tools. Observe the information printed in the operating instructions concerning operation, care and maintenance.
TPS Theft Protection System with Company Card, Company Remote and TPS‑K key (optional) TE 3000‑AVR detachable supply cord Use the Hilti chisels or other tools listed below. With these you will achieve higher performance and longer lifetime as the power tool and chisels have been optimized as a system.
Power tool TE 3000‑AVR Weight of power tool 29.9 kg (65.92 lb) Dimensions (L x W x H) 808 mm (31.81") x 610 mm (24.02") x 209 mm (8.23") Hammering frequency under load 860/min Single impact energy 68 J Weight of transport trolley 10.8 kg (23.81 lb) Information about the power tool and its applications Protection class...
Page 12
g) If devices are provided for the connection of dust 5.3 Additional safety instructions extraction and collection facilities, ensure these 5.3.1 Personal safety are connected and properly used. Use of dust a) Always hold the power tool securely with both collection can reduce dust-related hazards.
Dirty or dusty power tools which have been used frequently for work on conductive materials should be checked at regular intervals at a Hilti Service Center. Under unfavorable circumstances, dampness or dust adhering to the surface of the power tool, especially dust from conductive materials, may present a risk of electric shock.
Push the releasable electric plug connector into the that the power tool plus transport trolley present a con- supply cord plug on the power tool as far as it will siderable weight. CAUTION While pushing it in under light pressure, turn the Do not park the transport trolley on an incline.
Sections of the grip are made from a CAUTION synthetic rubber material. The power tool must always be checked by a Hilti Never operate the power tool when the ventilation slots specialist for internal or external damage whenever it are blocked.
Hilti for servicing in good time. damaged or when the controls do not function faultlessly. 8.4 Maintenance If necessary, the power tool should be repaired by Hilti WARNING Service. Repairs to the electrical section of the power tool may be carried out only by trained electrical specialists.
NOTE If the fault cannot be eliminated by the measures listed above, have the power tool checked by Hilti Service. 10 Disposal Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled.