Table of Contents
Advertisement
20
Draft setup
1. At the System menu 1, press
2. Press t or s to set draft. For example, if the depth readout is
5 feet lower than actnal depth, enter +5 feet.
Navigator setup
1. At the System menu 2, press
2. Press t or s to select NMEA input format of navigator; Ver.
1.5 or Ver. 2.0. (If you are unsure of the version no., try both
and select the one which successfully inputs nav data to the
sounder.)
3. To display nav data on the sounder displays, press
NAV DSP.
4. Press t or s to select which nav data to display; L/L (Posi-
tion), R/B (Range and Bearing to a Waypoint), or CSE (Course).
Speed data setup
1. At the System menu 2, press
2. Press t or s to select source of speed data; OWN (speed
sensor) or NMEA.
3. For speed sensor-equipped sets, you may offset the speed read-
out if it is wrong. Run the boat at various speeds and watch the
speed readout at the bottom of the screen. If it is unreasonably
wrong, press
to select SPD ADJ.
4. Press t or s to correct speed readout. For example, if the
readout is 10% lower than actual speed, enter +10.
Water temperature data setup
1. At the System menu 2, press
2. Press t or s to to select source of water temperature data;
OWN (water temperature sensor) or NMEA.
3. For water temperature sensor-equipped sets, you may offset
the water temperature readout if it is wrong. Watch the water
temperature readout at the bottom of the screen. If it is unrea-
sonably wrong, press
4. Press t or s to correct water temperature readout. For ex-
ample, if the readout is 2° higher than actual temperature, enter
-2°.
5. To display a water temperature graph (shows present water tem-
perature), press
The System menu 1 appears.
6. Press
to select TEMP GRAPH.
7. Press s to select ON.
to select DRAFT.
to select NMEA.
to select SPD SEL.
to select TMP SEL.
to select TMP ADJ.
to select MENU and press t to select 1.
to select
Hide quick links:
Advertisement
Table of Contents
