Furuno FCV-600L Installation Manual page 19

T-02MSB
Sensor
cable
Mounting procedure
1. Drill a hole of 21 mm in diameter in
the mounting location.
2. Pass the sensor cable through the
hole.
3. Pass gasket, washer and locknut
onto cable in that order.
4. Coat the sensor flange with high
quality sealant and then fasten the
sensor with the locknut.
(Torque: max. 59N·m)
5. Launch the boat to check for water
leakage around the sensor.
Thru-hull mount water temperature sensor
T-02MSB, T-03MSB
• Select a mid-boat flat position. The sensor does not have to be
installed perfectly perpendicular. The sensor must not be dam-
aged in dry-docking operation.
• Select a place apart from equipment generating heat.
• Select a place in the forward direction viewing from the drain
hole, to allow for circulation of cooling water.
• Select a place free from vibration.
Locknut
Washer
Gasket
φ21 mm
Coat with
sealant.
Holder Guide
Mounting procedure
1. Drill a hole of 25 mm in diameter in the mounting
2. Coat holder guide with high quality sealant, and
3. Set the sensor holder to the holder guide from
4. Launch the boat to check for water leakage
Figure 1-17 Thru-hull mount water temperature sensors
T-02MSB, T-03MSB
T-03MSB
φ25 mm
Coat with
sealant.
location.
pass gasket, washer and locknut onto holder
guide in that order and then tighten the locknut.
inside the boat and then tighten the locknut.
around the sensor.
Sensor Holder
Locknut
Locknut
Washer
Gasket
Plate thickness
within 25 mm
13