Directions For Disassembly And Adjustment; Key Points In Dissassembly; Method Of Disassembling The Control Panel - Daewoo DWF-270G Service Manual

5. DIRECTIONS FOR DISASSEMBLY AND ADJUSTMENT

Warning
BEFORE ATTEMPTING TO SERVICE OR ADJUST ANY PART OF THE WASHING MACHINE, DISCONNECT
THE POWER CORD FROM THE ELECTRIC OUTLET.
KEY POINTS IN DISASSEMBLY
1) GENERAL ATTENTION
Be sure to pull off the power plug in disassembly or maintenance.
Use stipulated crimp terminals in connecting the wires between the conducting wires as far as possible, and
fix with suitable tools, and insulate with insulation tape completely.
In inserting the conducting wires, be sure to plug the pins to the root and make it hard to be pulled out.
If welding is needed, be careful not to touch the plastic or other insulation parts with the iron.
When connecting the wires, be sure not to make the wire touch the mobile parts like the belt, radiating pulley
and jib etc., and the sharp protruding parts and the parts with high temperature (motor).Connect and fix the
wires as per their original mode.
If there's metal object at the wire fixing point, be sure to insulate with insulation materials.
Take care of the screws in order to use them in installation.
2)POINTS OF ATTENTION IN USAGE OF ELECTRIC COMPONENTS
In case that the power is on, the earthing circuit of the computer sequencer can have a high voltage to earth.
Take care not to get electric shock.
Store the computer sequencer at shading and dry places. Avoid direct sunlight.

METHOD OF DISASSEMBLING THE CONTROL PANEL

1. Open the back cover. Loosen
the inner wiring.
ATTENTION:
Do not lift the control panel seat by force, otherwise the safety switch control rod may get transformed, and the
jointer part of the connecting pipe of the water level sensor may be loosened, therefore influence the normal
operation of the microswitch and water level sensor.
After opening the control panel seat, hold it with one hand or lean it on supporter like the wall. Do not put it down.
POINTS OF ATTENTION IN ASSEMBLY
Fix the wiring in the control panel seat to its original position. Do not make it touch sharp corner and mobile position.
The space surrounding the computer sequencer is rather narrow. Please dispose it carefully and do not make the
transformer press the wires.
Confirm that the control panel seat is installed to proper position of the Cabinet.
2. Loosen the screws used to
install the control panel seat(rear
and side) .Lift the rear upwards.
Loosen the control panel seat from
the inlay of the cabinet. Then move
it forwards several times.
3.Turn the control panel seat
backwards to open it gently. Do not
open by force.
DIRECTIONS
9