Making The Printer Driver Known From The Network Window - Konica Minolta Bizhub 652 User Manual

4.1 Windows Vista/7/Server 2008/Server 2008 R2

Making the printer driver known from the Network window

To use Web service print in Windows Vista/7/Server 2008/Server 2008 R2, install the printer driver before
making it known to the computer with plug and play.
0 Installing the driver to Windows Vista/7/Server 2008/Server 2008 R2-based computers requires the ad-
ministrator authority.
1
Install the printer driver for this machine.
% Install the printer driver using the Add Printer Wizard.
The printer driver can be installed in any port.
For details, refer to page 4-3.
2
Turn on the power of the machine while it is connected to the network.
Since the printer is searched for, be sure to connect the machine to the network.
3
To use the Web service print, check that [Network discovery] is enabled in [Network and Sharing Cent-
er] on the computer.
4
Open the [Network] window.
% In Windows Vista/Server 2008, click [Start], and [Network].
% In Windows 7/Server 2008 R2, open [Computer] and click [Network].
If [Network] is not displayed in [Computer], click the [Network and Internet] category on the [Control
Panel], and also click [View network computers and devices].
Connected computers and devices are detected.
5
Select the device name of the machine, and then click [Install] on the toolbar.
% To check the device name, select [Network Settings] - [Web Service Settings] - [Printer Settings] in
[Administrator Settings] of this machine. In the default setting, the last six characters of [Printer
name] correspond to the low-order three bytes of the MAC address.
To check the MAC address, select [Configuration Page]. For details on how to output [Configuration
Page], refer to page 12-28.
The printer driver for this machine is detected and the machine is ready to print.
6
After finishing the installation, make sure that the icon for the installed printer is displayed in the [Print-
ers] or [Devices and Printers] window.
Reference
- If the printer driver is not correctly installed, the driver must be updated using [Update Driver...]. For
details, refer to page 4-13.
- In Windows Vista/Server 2008, you can continue the task and specify the printer driver installation disk
to install the printer driver if it is not installed in advance. When the [Found New Hardware] window ap-
pears, follow the displayed messages to perform the procedure. For details, refer to Steps 11 through
20 in the succeeding section.
- In Windows 7/Server 2008 R2, you cannot specify the installation disk after the machine is connected
to the computer. Install the printer driver in advance (Step 1).
bizhub 652/552
4
4-9