To Shut Down The Boiler; Light Effect - Baxi Bermuda SP3 Renewal Operating Instructions Manual

RESETTING THE BOILER:
7
(Electronic Controls Boiler)
(45/3E, 57/3E, 45/4E & 57/4E)
If the boiler lockout light is illuminated
it is necessary to reset the appliance.
To do this turn the boiler thermostat
control knob fully anti-clockwise to
the OFF position and wait 10
seconds. Turn the control knob to the
required setting. The boiler will
commence sparking providing the
water temperature is sufficiently cool.
(51/5)
If the indicator light is illuminated
red/or flashing red, it is necessary to
reset the appliance. To do this turn
the boiler thermostat control knob
fully anticlockwise to the OFF position
and wait until the light shows orange.
Turn the control knob clockwise to
the required setting. The boiler will
commence the ignition sequence.
8 TO LIGHT THE FIRE: Push in the
control knob. Turn to the
IGNITION position (
Sparking will commence and the pilot
will ignite. Continue to hold the
control knob in position for a further
15 seconds then release. The pilot
should stay alight.
NOTE:
If pilot or the fire fail to remain
alight or are extinguished at any time,
wait at least 2 minutes then repeat the
procedure from the start of "8 TO LIGHT
THE FIRE". Once lit the pilot may be left
on permanently.
CONTROL KNOB POSITIONS: The
control knob has six positions giving
a choice of 5 settings, i.e.
Position - OFF
Position - IGNITION/PILOT
Position 1 - LOW
Position 2 - MEDIUM
Position 3 - MED/HIGH
Position 4 - HIGH
To adjust the fire to the required
setting, push in the control knob and
turn in the appropriate direction.
TO TURN THE FIRE OFF: Push
9
in the control knob and turn
clockwise to the OFF position.
The pilot light can be left on by
stopping at the position but the
fire is not completely off until the
control knob is turned to position

LIGHT EFFECT

The light effect is operated by a
switch below the control knob and
may be used either with or without
the fire being on.
BAXI BERMUDA SP3
) and hold.
BAXI BERMUDA VP3
.
page 5

TO SHUT DOWN THE BOILER

(Bermuda SP3) Open the controls
access panel by pushing forward at
the bottom. Lift the panel and pull
forward to fix in the open position.
(Bermuda VP3) Remove the fender
front at the bottom of the fire by
pulling forward.
To switch the boiler off for short
periods. (Manual Controls Boiler)
Turn the boiler thermostat knob to the
OFF position ( ). The pilot will remain
alight.
To switch the boiler off for long
periods. (Manual Controls Boiler)
Turn the grey push button clockwise
and release. Turn
thermostat knob to the OFF position
( ).
To switch the boiler off. (Electronic
Controls Boiler) Turn the thermostat
knob to the OFF position (
If you are shutting down both the fire
and boiler, isolate the electrical supply
that serves the system controls i.e.
Timer/Programmer.
Replace the controls cover panel.
NOTE:
If the boiler is left off for long
periods during cold weather, it is
recommended that the whole system is
drained to avoid frost damage. Advice on
draining the system can be obtained from
your Service Engineer.
GUARDING
The glass front panel on this
appliance conforms to the required
safety standards. It does not give full
protection to the young or infirm: in
such cases we recommend a nursery
type guard which conforms to BS
6539. The panel becomes very hot
when the appliance is in use and
must not be touched.
THE APPLIANCE MUST NEVER BE
USED WITHOUT THE GLASS
FRONT PANEL FITTED.
the boiler
).