Route Monitoring - Furuno FCR-2107 series Operator's Manual

Route monitoring

Selecting route to monitor
Set arrow on Route in the information area, click the Monitor
button, spin the scrollwheel to select route then push the
scrollwheel.
Setting destination waypoint
1. Open the Monitor Route dialog box, select route at the information area and
click the Monitor button.
2. Set the arrow in the To WPT box, spin the scrollwheel to select waypoint.
3. Push the scrollwheel to confirm selection.
Displaying monitor route
Displaying route to monitor
1. Spin the scrollwheel to show Symbol Display/Info/ in the guidance box and left-click
to show the Symbol Display dialog box.
2. Click the arrow tab to show the Route menu.
Check or uncheck Center line, Channel limit, Leg marks, Wheel over line.
(WPT mark is permanently checked.)
- Leg mark: Show planned speed and planned steering in nav route.
- Wheel over line: Show point where turn on next waypoint is to begin.
Select Route
X
Monitor
DISP
Plan
DISP
13
Alerts
WPT
WPT
NM
WPT
NM
WPT-mark