Sony BDV-T10 Operating Instructions Manual page 18

Hole on the back of
the speaker
Color tube
Front left speaker (L): White
Front right speaker (R): Red
Center speaker: Green
Surround left speaker (L): Blue
Surround right speaker (R): Gray
G
\\\\\\\\\\\\\\1>
~
4 mm
(5/ 32
inch)
~
. 1
30 mm (1
3/ 16
inches)
18
US
To install the speakers on a wall
Before installing the speakers on a wall, connect the speaker cord to the speaker.
Be sure to match the speaker cords to the appropriate terminals on the speakers: the speaker cord with
the color tube to
~,
and the speaker cord without the color tube to
8.
Caution
• Contact a screw shop or installer regarding the wall material or screws to be used.
• Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach
the screws securely to a beam and fasten them to the wall. Install the speakers on a vertical and flat wall where
reinforcement is applied.
• Sony is not responsible for accidents or damage caused by improper installation, insufficient wall strength or
improper screw installation, natural calamity, etc.
1
Prepare screws (not supplied) that are suitable for the hole on the back of each speaker.
See the illustrations below.