Adjusting The Primary Interlock Switch - New Switch Setup; Primary Switch Adjustment And Parts - TurboChef TORNADO Service Manual

THE OVEN DOOR
42
72 71
73
74

3 2 : Primary Switch Adjustment and Parts -

F I G U R E
New Switch Setup
ADJUSTING THE PRIMARY INTERLOCK SWITCH -
NEW SWITCH SETUP
The new switch assembly is identifiable by the pri-
mary switch being located on the left side of the
oven. Also, the serial number of the oven will fol-
low the formatting below (X = variable digit/letter):
NGCD(5 thru
NGCXXD(5 thru
1. When the oven completes
required, see page 38), closely examine the latch
toggle position using the door switch gauge
(Item 75).
2. If the toggle is past the top of the window, you
must correct the toggle's position by installing
an 0.030" Shim (Item 76). See Figure 32.
3. Verify position of toggle by opening and closing
the oven door.
4. With the toggle correctly adjusted and the door
closed, adjust the primary switch by loosening
the two #4-40 screws and #8-32 screw.
5. Using a 0.030" (0.762 mm) spacer as a template
(included with Item 74), adjust switch lever
position to a maximum allowable distance of
0.030" (0.762 mm).
6. Open and close the door several times to verify
the switch gap.
-
APPLY HI TEMP
GREASE TO AREA
1
75
9)XXXX (North America)
9)XXXX (International)
(if
BURN IN
70
2
3
PRIMARY SWITCH ADJUSTMENT AND PARTS
Figure 32
70. 102809
71. 102921
72. 101555
73. 102012
74. NGC-3033
75. Adjustment Tools (included with Item 74)
NGC-1215
NGC-1340
NGC-1344
76. NGC-1169-1 Shim, 0.030"
NGC-1169-2 Shim, 0.045"
*Refer to FSB-10057 (included with Item 74) for
instructions on converting NGC-3033 kit into the
new switch assembly.
Assembly Notes
1. Tip of toggle must be within window notch.
Optimal is centered or below centered when the
oven is hot.
2. Tip of toggle adjustment notch. Toggle must be
within notch when oven is hot.
3. If toggle "hangs" in position as shown, decrease
number of shims.
76
Screw, #8-32 x 3/8" 100Þ CSK
Screw, #8-32 x 3/8"
Screw, #4-40 x 3/4"
Interlock Switch
Assy, Door Switch*
Door Switch Gauge
Shim Tool, 0.060"
Shim Tool, 0.030"