Connecting The Power Cord - Pioneer AVH-X4690DVD Owner's Manual

Section
23 Connection

Connecting the power cord

Microphone input
(Function of AVH-X5690BT and AVH-X2690BT)
Antenna input
This product
Yellow
Connect to the constant 12 V supply terminal.
Orange/white
Connect to lighting switch terminal.
Red
Connect to terminal controlled by ignition switch (12 V DC).
Black (chassis ground)
Connect to a clean, paint-free metal location.
Front speaker
Left
White/black
Rear speaker or
Subwoofer (4 Ω)
Green/black
When using a subwoofer of 70 W (2 Ω), be sure to connect with Violet and Violet/black leads of this
unit. Do not connect anything to Green and Green/black leads.
Green
Not used.
Green/black
44
En
Fuse (10 A)
AUX jack (3.5 ø)
Use a mini plug cable to connect with auxiliary
device.
White Gray
Front speaker
Right
Gray/black
Green Violet
Rear speaker or
Subwoofer (4 Ω)
Violet/black
Violet
Subwoofer (4 Ω)
× 2
Violet/black
Connection
4 m
Microphone (Function of AVH-X5690BT and AVH-X2690BT)
Wired remote input
Hard-wired remote control adapter can be connected
(sold separately).
Violet/white
Of the two lead wires connected to the back lamp, connect the one in which the voltage changes
when the gear shift is in the REVERSE (R) position. This connection enables the unit to
sense whether the car is moving forwards or backwards.
Yellow/black
If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that
equipment. If not, keep the Audio Mute lead free of any connections.
Light green
Used to detect the ON/OFF status of the parking
brake. This lead must be connected to the power
supply side of the parking brake switch.
Blue/white
Connect to system control terminal of the power amp or
auto-antenna relay control terminal (max. 300 mA 12 V DC).
With a 2 speaker system, do not connect anything to the speaker leads
that are not connected to speakers.
Parking brake
switch
Power supply side
Ground side
Note:
· Change the initial setting of this unit.
The subwoofer output of this unit is
monaural.