Setup Page - AMX Network Lighting Solution ALD-H48 Instruction Manual

Network lighting solution dimmer interface

Hide thumbs Also See for Network Lighting Solution ALD-H48:

Table of Contents

2. Push the "%" button to open the keypad, type the percentage value for the dimmer.

3. Push Go to set the dimmer intensity.

Setup Page

Opening the Setup page places the ALD-H48 in addressing mode which will allow you to allocate

addresses to attached dimmers. It is recommended you address your dimmers at the time your

lighting system is first installed. The Setup page has a total of 48 buttons (8 per each of the 6 buses)

shown below.

FIG. 10 Setup Page

It is important to remember which bus the dimmer is physically connected to when addressing.

ALD-H48 Lighting Controller

Push the Ramp Up and Ramp Down buttons to raise and lower the dimmer levels

incrementally.

Using The Touch Panel Pages

Table of Contents