Programming the Delta System
Program Menu Selections
Each of these program menu selections is detailed in the subsequent pages of this section.
In screens with multiple lines of selections, an arrow is used to indicate which line of information is
currently active (FIG. 20).
FIG. 20
Arrow Indicates Which Line of Information Is Currently Active
Setup Program Menu
The menu selection immediately defaults to the Exit selection in the first screen of the Program Menu.
The other menu choices are Controller, Tuner and Clock.
Selecting Controller(FIG. 21) will lead the user through:
FIG. 21
Setup Menu - Controller
Selecting "Tuner" (FIG. 22) will lead the user through setting the presets.
FIG. 22
Setup Menu - Tuner
"Tuner" will only be displayed if a Tuner is detected on board the Delta Controller. If a
tuner board is not installed, there will be no "Tuner" selection displayed.
30
Setup is where the user will program Sources, access Tuner and Clock information.
Preferences allow user to set up preferences for Backlight and Display Options.
About displays the Version # for the Controller firmware.
Nav UP/DOWN moves the arrow focus between the active and inactive lines of information.
Once the programming selections the user wants are "active", Nav LEFT/RIGHT will move
from option to option.
Nav CENTER is used to make a selection as if to be an ENTER or OK command.
Program Sources.
View the Room Info for each zone.
Adjust the Source Leveling for each source.
Delta Series Audio Controllers