GE CustomStyle Profile Performance 22 Owner's Manual page 24

Reversing the hardware.
Read these instructions completely and carefully.
Transfer the Spring and Wheel Assembly to the Left Side
Using needle nose pliers, tightly grip the spring and
1
unhook it from the bottom rail.
Pull the assembly out through the hole in the front rail,
2
being careful not to drop the spring.
Reinsert the assembly on the other side. This is done by
3
inserting the spring through the large slot in the bottom
rail, so that the end loop is visible through the mounting
hole for the mechanism. Hook this loop on the wheel
mechanism, then mount it in place.
Again, tightly grip the spring with the needle nose pliers
4
and hook it onto the bottom rail.
Transfer Middle Hinge Bracket to the Left
With a Phillips screwdriver, remove the cam riser
1
from the middle hinge and place it aside.
Remove the middle hinge, along with the shim,
2
by removing the three Torx screws.
Remove the three Torx screws from the middle left side
3
of the cabinet. Screw them into the holes on the right
side. (Do not overtighten.)
Place the shim and middle hinge bracket over the holes
4
at the middle left side of the cabinet. Insert and tighten
the three screws.
Reattach the cam riser to the top of the middle
5
hinge bracket.
24
Spring and Wheel
Assembly
Middle Hinge
Bracket
Cam Riser