Table of Contents
Advertisement
Ô
NOTES
• If you place the handset
on the base to recharge
it while the headset is
connected, be sure the
handset seats properly.
• You can use a handset
holder (available from
your local RadioShack
store) to hang the
handset on your belt for
greater convenience
when using a headset.
30
4. After the command has finished, you hear
intermittent beeps indicating that the system is
in the command waiting mode. You may enter
another command at this time from the chart on
step 3.
5. When you are finished, press
system. The answering system automatically
returns to standby.
ADDITIONAL
INFORMATION
I
NSTALLING THE
B
ELTCLIP
To attach the beltclip
Insert the beltclip into the holes on each side of the
handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs
from the holes.
H
EADSET
You can connect an optional headset with a
inch (2.5-mm) plug. Contact RadioShack for a
Ô
suitable headset.
To connect the headset, open the rubber cover on
the side of the handset. Then insert the headset's
plug into the jack. Ô
When you finish using the headset, disconnect it
from the handset and close the rubber cover to
protect the jack.
O
PTIONAL
I
NSTALLATION
to exit the
END
3
/
-
32
Advertisement
Table of Contents
