Electrolux Washing machine User Manual page 23

6. Remove the 4 plugs from the literature pack
located in the drum and install them in the
holes vacated by the packaging spacers.
Positioning
Install the appliance on a flat hard floor. Make
sure that air circulation around the appliance is
not impeded by carpets, rugs etc. Check that
the appliance does not touch the wall or other
kitchen units. Level the appliance by raising or
lowering the feet. The feet may be tight to
adjust as they incorporate a self locking nut,
but the appliance MUST be level and stable.
Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and
displacement of the appliance during operation.
Never place cardboard, wood or similar
materials under the appliance to compensate
for any unevenness in the floor.
Pedestal
A pedestal accessory, Model No. APWD15W
(White), APWD15GB (Glacier Blue), APWD15P
(Platinum) and APWD15E (Black), specifically
designed for this washer may be used when
elevating the appliance for ease of use. Failure
to use accessories certified by the
manufacturer could result in personal injury,
property damage or damage to the appliance.
Installing an appliance on the pedestal could
cause an increase of vibration and noise,
especially during spinning phases. By
simoultaneously pressing buttons
some seconds it's possible to reduce the
vibration and the noise.
If necessary, check the
setting with a spirit
level.
2 3
and for
Water inlet
Do not use the hose from your previous
appliance to connect to the water supply.
Warning!
Do not place the inlet hose downwards.
Angle the hose to the left or right
depending on the position of your water
tap.
1. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure
to tighten the ring nut again to prevent water
leaks.
do not wish to move the tap, you will have to
purchase a new, longer hose specially
designed for this type of use.
Water drainage
The end of the drain hose can be positioned in
three ways:
2. Connect the hose
to a tap with a 3/4"
thread. Always use
the hose supplied with
the appliance.
The inlet hose must
not be lengthened. If
it is too short and you
Hooked over the
edge of a sink using
the plastic hose
guide supplied with
the appliance. In this
case, make sure the
end cannot come
unhooked when the
23