Electrolux Washing machine User Manual page 15

Note: To provide the best care for your laundry,
not every setting or option is available with
every programme. If a setting or option is not
available, its pilot light will not light up.
IMPORTANT!
Adjustments to the programme will be
remembered each time that a programme is
selected in the future. To return to the factory
settings, simoultaneously press the buttons
5
and until an acoustic signal sounds.
7. Select the delayed start
10
button
Press this button to select the required delay.
The selected delay time value will appear on
the display for few seconds, then the duration
of the programme will appear again.
You must select this option after you have set
the programme and before you press the
8
button .
You can cancel or change the delay time at
any moment, before you press the button
you have already pressed it, and you wish to
cancel or change the delay time, proceed as
follows:
• set the appliance to PAUSE by pressing the
8
button ;
10
• press the button
will appear the symbol «
delay.
8
• press the button again to start the
programme.
IMPORTANT!
• The door will be locked throughout the delay
time. If you need to open the door, you must
first set the appliance to PAUSE by pressing
8
the button and then you can open the door.
After you have closed the door, press the
8
button again.
8. Start the programme by pressing button
8
To start the selected programme, press this
button. The DOOR LOCK pilot light will light up
and the actual programme phase pilot remains
by pressing the
8
once until on the display
» or the desired
0'
lit to indicate that the appliance starts operating
and the door is locked.
The appliance will not operate with the door
open. The programme phase lights will blink,
the acoustic signal will beep and «DR» will be
displayed as a reminder to close the door.
9. Altering an option of a running
programme
8
It is possible to change some options before
the programme carries it out.
Before you make any change, you must pause
the washing appliance by pressing the button
8
.
To carry on the programme, press the button
again.
The SIGNAL VOLUME can be changed at any
time.
10. Cancelling or changing a running
programme
Press the button
. If
which is running. The appliance is now
switched off. To switch it on again, just press
any button or turn the programme selector dial.
The appliance will show the last selected
programme. Now you can select a new
programme. The washing water in the tub will
not empty out. It's not possible to change a
running programme without cancelling it and
then setting a new programme.
11. Interrupting a programme and opening
the door after the programme has started
If you wish to add a forgotten item to the wash
drum, first set the appliance to pause by
pressing the button
displayed alternately with the estimated
programme time.
If the pilot light DOOR LOCK starts blinking
and after some minutes goes off, the door can
be opened. If it does not switch off, this means
that the appliance is already heating, that the
water level is above the bottom edge of the
door. In this cases the door cannot be opened.
If you cannot open the door but you need to
open it, you have to switch the appliance off by
7
to cancel a programme
8
. The message «PAU» is
8
15