Canon Selphy DS810 Photo Printing Manual page 82

Troubleshooting
Possible Cause
I
Try This
Curled paper used
If all four corners or the printing surface of the paper is curled, the
paper may become dirty or the paper may not feed properly. Use
the paper after correcting paper curl as follows.
(l)Face up the printing surface*1, and cover it with a non-printing
regular paper to avoid damaging the surface.
(2)Roll up the paper in a direction opposite to paper curl as the
figure below.
~
,
CX*l
(3)Check the printing paper if paper curl is corrected within
approximately 2 to S mm *2.
It is recommended to print the curl-corrected paper one sheet at
atime.
W
Note
Sets time to dry ink on the printing surface.
In case the ink is still wet and the print surface becomes dirty, set longer time to dry
ink.
1
Press the Menu button.
2 Select Tool box and then press the OK button.
3 Select Device settings and then press the OK button.
4 Select Print settings and then press the OK button.
S Select Ink drying wait time and then press the OK button.
6 Select Standard, Long or Longer and then press the OK button.
80