Installation Of Compact Flash Upgrades - AMX NetLinx Integrated Controllers NXI-x000 Series Hardware Reference Manual

Installation and Upgrading
Mounting
Brackets
Compact Flash
Compact Flash
insert location
FIG. 3 Location of the Compact Flash within a sample Integrated Controller
3. Carefully pull-up and remove the housing up and away from the Controller to expose the internal
circuit board (FIG. 3).
4. Refer to the followingInstallation of Compact Flash Upgradesfor detailed replacement information.

Installation of Compact Flash Upgrades

1. Discharge any static electricity from your body by touching a grounded metal object.
2. Locate the 32 MB Compact Flash card on the main board. For more detailed information on
component locations, refer to FIG. 3.
3. Insert the tip of a grounded flathead screwdriver into one of the Card Removal Grooves (located on
either side of the card), and gently pry the card out of the slot. Repeat this process on the opposite
card removal groove. This alternating action causes the card to "wiggle" away from the on-board
connector pins.
4. Slip your finger into the opening between the connector pins and the card, and push the card out to
remove it.
5. Remove the upgrade card from it's anti-static bag.
6. Insert the upgrade card into the connector opening with the arrow facing towards the pins, then push
it in firmly until the contact pins are completely inside the flash card and securely attached to the
connector (FIG. 4).
18
NXC Card Slot
faceplate
Chassis housing screws (top)
- 6 on top
- sides vary per model
Chassis housing screws (side)
- 4 on each side of the NI-4000
- 3 on each side of the
NI-3000/2000
NXC Card Slots
NI-2000, NI-3000, NI-4000 Hardware Reference Guide