Power Connector Cables - Intel Xeon LV User Manual

Figure 28.

Power Connector Cables

2. Plug the main connector into the motherboard located in coordinate K3-4 making
sure that the plug clip lines up with the clip lock and the connector pins fit easily
into their appropriate slots.
Warning: Do NOT force the ATX power plug into the connector, it should go in easily when
plugged in correctly. Plugging it in incorrectly will result in severe DAMAGE to the CRB.
3. Plug the four-pin connector that has two yellow wires and two black wires into the
four-pin connector that is approximately 1 inch to the right of the main ATX power
connector in coordinate K5.
4. Plug in the power connectors from each of the hard drives and disc drives.
5. Plug the power cable into the back of the power supply leaving the switch in the off
position (switch pushed down to the side with the "0" on it) and PLUG THE CORD
INTO THE WALL ONCE THE BOARD IS SETUP. You can also turn the power supply
switch to the on "1" position once the CRB is setup.
Dual-Core Intel® Xeon® Processor LV and Intel
User's Manual
36
This connector is
NOT USED
This connector is
USED
®
3100 Chipset
Platform Setup
B5792-01
January 2007
Order Number:315879-002