Table of Contents
Advertisement
Installation -
Cabling
1
Network
Connection
2
Video Output(BNC)
4
Sensor/
Alarm Input
5
Relay Output
Mic.
Amplifier
Mic.
3
Power
6
7
Audio In
Audio Out
Speaker
1
Network Connection
Connect the crossover cable into the RS-45.
2
Video Output(BNC Cable)
The BNC cable is used to connect to a monitoring display.
3
Power Connection
Please, check the voltage and current capacity of rated
power carefully.
Rate Power
Current Consumption
DC 12V
4
Sensor/Alarm Input
It connects to IR sensor, IrDA sensor or door switch. If the
sensor is activated, it can activate to move camera to the
specific angle and to connect the alarm device.
5
Relay Output
It connects to the alarm lights, siren or lamps.
RS-485(2M Camera Only): Controls with device using RS-485
communication standards.
RS-485
6
Audio In
Connect the 'Audio In' port of the camera to the
microphone directly or 'Line Out' port of the amplifier
connected with microphone.
If the microphone is connected directly, the microphone with the
embedded amplifier such as condenser mic. needs to be used.
7
Audio Out
Connect the 'Audio Out' port of the camera to the 'Line In'
port of the speaker.
If the speaker without the amplifier is connected to Audio Out
port, it doesn't work properly. Therefore, the speaker with the
amplifier or the separate amplifier is needed.
9
PoE
5.5W
IEEE802.3af Class 0
Advertisement
Table of Contents
