Table of Contents
Advertisement
Network Setup -
IP Installer
1
2
2. IP Installer details
Search: IP installer searches and lists all IP
1
cameras connected to the current PC within
LAN. Re-click "Search" unless all IP cameras
are listed.
IP Camera List: Searched IP cameras are listed.
2
By clicking it, you can see information on the
camera name, IP and port setting on the right.
3
Device Info: Model name is shown.
Network Type: Choose Network Type.
4
Normally choose Static IP. In case that it is dynamic and get it via
DHCP server, choose Dynamic IP.
Choose Static IP when sharing IP address via IP router.
Enter suitable information on IP address, Subnet Mask, Gateway,
DNS for installation setting.
If it is Static IP, you can get the information from the Internet service
provider.
IP Setting: Configure IP setting.
5
Port Setting: Configure Port Setting.
6
You don't need to change the setting when connected to IP
camera via IP router or within LAN. However, a port forwarding
is required to allow remote access to the IP camera within LAN
by external host. For the setting, refer to instructions of the IP
Router.
Case 1. Connection within LAN / via IP Router,
Model name
Case 2. Remote Connection by external host after port forwarding,
Authentication: Before saving settings, enter an ID and PW.
7
Default ID and PW are admin; admin.
For security reasons, recommend changing the ID and PW. For
configuration, go "Webviewer>Administrator tool(
Users".
When factory reset the camera, both ID and PW are also reset.
Save: Click this button to save all settings.
8
It takes the camera one and a half minutes and it will reboot after
saving it automatically.
Uninstall (SD, HD): To make webviewer work, Active X should
9
be installed to PC. The Webviewer might not be seen because
of crash between previous installed one and this one.
Then click this button to uninstall/remove the previous one
and reinstall one of webviewer.
12
1) Open the Internet Browser.
2) Enter an IP address and HTTP port into the address bar.
Case 2.1) HTTP default value is not 80
e.g.) IP: 192.168.1.80, HTTP: 8080
http://192.168.1.80:8080
Case 2.2) HTTP default value is 80
e.g.) IP: 192.168.1.80, HTTP: 80
http://192.168.1.80
1) Open the Internet Browser.
2) Enter an IP address and HTTP port into the address bar.
e.g.) IP: 192.168.1.100, HTTP: 8888
http://192.168.1.100:8888
3
4
5
6
7
8
9
)>System>
Advertisement
Table of Contents
