EverFocus EDN Series User Manual page 51

Day Profile / Night Profile: Select Day Profile to configure the following settings for daytime and
select Night Profile to configure the following settings for nighttime. Click the Apply button to save the
settings.
【Exposure Settings】 This function can only be set up in the Advanced tab. This setting is used to adapt
to the amount or type of light used by the camera.
Mode: Select a mode from the drop-down list.

Auto: Selecting Auto for the camera to automatically adjust the Shutter based on the
•
measured light level.
ALC (Shutter Priority): Selecting ALC (Automatic Light Control) allows the camera circuitry to
•
either take bright spots more into consideration (peak), bringing out detail in bright areas, or
less into consideration (average) bringing out detail in shadows.
Manual: Select this option to manually set up the Shutter (Manual) and AGC (Manual) values.
•
Shutter (Manual): The function is only activated if you select ALC or Manual in the Mode field. If

enabled, this setting lets you set the shutter speed yourself (measured in fractions of a second).
AGC (Manual): The function is only activated if you select Manual in the Mode field. Set the Auto

Gain Control limit here. The lower the AGC level, the lower the video signal and the noise.
Slow Shutter: The function is only activated if you select Auto in the Mode field.

AGC: The function is only activated if you select Auto or ALC in the Mode field. Set the Auto Gain

Control limit here. The lower the AGC level, the lower the video signal and the noise.
Flickerless: The function is only activated if you select Auto in the Mode field. Choose between

OFF, 50HZ, 60HZ, 50HZ (High Luminance) or 60HZ (High Luminance).
Click Apply to apply the changes or Cancel to cancel the changes and return to the previous settings.
【Backlight Compensation Settings】This function is useful when the background of the subject is very
bright and the subject itself is dark. Click Apply to apply the changes or Cancel to cancel the changes
and return to the previous settings.
BLC Edit Mode: Click the Enable button, the BLC grids appear on the image. Click on the grids to

enable / disable the BLC function. The selected grids (in green) will be applied with the BLC
function.
EDN Series Mini Indoor IP Dome
45