Compliance Information; Declaration Of Conformity - Cisco Explorer 4540HDC User Manual

United States
FCC Compliance
This device has been tested and found to comply
with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
such interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
OFF and ON, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the cable company or an experienced radio/
television technician for help.
Any changes or modifi cations not expressly approved
by Scientifi c-Atlanta, Inc., could void the user's
authority to operate the equipment.
The information shown in the FCC Declaration of
Conformity paragraph below is a requirement of the
FCC and is intended to supply you with information
regarding the FCC approval of this device. The phone
numbers listed are for FCC-related questions only and
not intended for questions regarding the connection
or operation for this device. Please contact your cable
service provider for any questions you may have
regarding the operation or installation of this device.

Declaration of Conformity

This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
1) the device may not cause harmful interference, and
2) the device must accept any interference received,
including interference that may cause undesired
operation.
EXPLORER 4540HDC and 4550HDC
Digital Interactive Set-top
Model: 4540HDC and 4550HDC
Manufactured by: Scientifi c-Atlanta, Inc.;
5030 Sugarloaf Parkway;
Lawrenceville, Georgia 30044; USA
Telephone 770-236-1077
Canada EMI Regulation
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la class B est conforme à
la norme NMB-003 du Canada.
Software and Firmware Use
Scientifi c-Atlanta, Inc. owns copyrights to the software
included in your set-top and furnishes the software
to your cable service provider under a license
agreement. You may only use or copy this software
in accordance with the terms of your cable service
provider.
Scientifi c-Atlanta, Inc. owns copyrights to the fi rmware
in this equipment. You may only use the fi rmware in
the equipment in which it is provided. Any reproduction
or distribution of this fi rmware, or any portion of it,
without the express written consent of Scientifi c-
Atlanta, Inc. is prohibited.
Trademarks
Scientifi c Atlanta and Explorer are registered
trademarks of Scientifi c-Atlanta, Inc.
4540HDC and 4550HDC are trademarks of
Scientifi c-Atlanta, Inc.
Cisco, the Cisco logo, and Cisco Systems are
trademarks or registered trademarks of Cisco
Systems, Inc. and/or its affi liates in the U.S. and
certain other countries.
"Dolby" is a trademark of Dolby Laboratories.
HDMI, the HDMI logo, and High-Defi nition Multimedia
Interface are trademarks or registered trademarks of
HDMI Licensing LLC.
CableCARD and M-Card are trademarks of Cable
Television Laboratories, Inc.
MoCA is a trademark of Multimedia over Coax
Alliance.
All other trademarks shown are trademarks of their
respective owners.
Disclaimer
Scientifi c-Atlanta, Inc. assumes no responsibility for
errors or omissions that may appear in this guide.
Scientifi c-Atlanta, Inc. reserves the right to change
this guide at any time without notice.
20060628 FCC Standard
21