Compliance Information - Cisco Explorer 4540HDC User Manual

FCC Compliance
United States FCC Compliance
This device has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
such interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy. If
not installed and used in accordance with the instructions,
it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment OFF and ON, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna, if applicable.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit diff erent
from that to which the receiver is connected.
• Consult the cable company or an experienced radio/television
technician for help.
Any changes or modifi cations not expressly approved by Cisco
Systems, Inc., could void the user's authority to operate the
equipment.
The information shown in the FCC Declaration of Conformity
paragraph below is a requirement of the FCC and is intended to
supply you with information regarding the FCC approval of this
device. The phone numbers listed are for FCC-related questions
only and not intended for questions regarding the connection
or operation for this device. Please contact your cable service
provider for any questions you may have regarding the operation
or installation of this device.
Declaration of Conformity
This device complies with Part 15 of FCC Rules. Operation is
subject to the following two conditions: 1) the device may not
cause harmful interference, and 2) the device must accept any
interference received, including interference that may cause
undesired operation.
Cisco Explorer 4540HDC Digital Interactive Set-Top
Model: 4540HDC
Manufactured by: Cisco Systems, Inc.
5030 Sugarloaf Parkway
Lawrenceville, Georgia 30044 USA
Telephone: 678 277-1120
Canada EMI Regulation
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la class B est conforme à la norme
NMB-003 du Canada.
Software and Firmware Use
The software described in this document is protected by
copyright law and furnished to you under a license agreement.
You may only use or copy this software in accordance with the
terms of your license agreement.
The fi rmware in this equipment is protected by copyright law.
You may only use the fi rmware in the equipment in which it is
provided. Any reproduction or distribution of this fi rmware, or any
portion of it, without our express written consent is prohibited.
AVC VIDEO LICENSE
With respect to each AVC/H.264 product, we are obligated to
provide the following notice:
THIS PRODUCT IS LICENSED UNDER THE AVC PATENT
PORTFOLIO LICENSE FOR THE PERSONAL AND NON-
COMMERCIAL USE OF A CONSUMER TO (i) ENCODE VIDEO
IN COMPLIANCE WITH THE AVC STANDARD ("AVC VIDEO")
AND/OR (ii) DECODE AVC VIDEO THAT WAS ENCODED
BY A CONSUMER ENGAGED IN A PERSONAL AND NON-
COMMERCIAL ACTIVITY AND/OR WAS OBTAINED FROM A
VIDEO PROVIDER LICENSED TO PROVIDE AVC VIDEO. NO
LICENSE IS GRANTED OR SHALL BE IMPLIED FOR ANY OTHER
USE. ADDITIONAL INFORMATION MAY BE OBTAINED FROM
MPEG LA, L.L.C. SEE HTTP://WWW.MPEGLA.COM.
Accordingly, please be advised that service providers, content
providers, and broadcasters are required to obtain a separate use
license from MPEG LA prior to any use of AVC/H.264 encoders
and/or decoders.
ROVI CORPORATION COPYRIGHT
NOTICE
This product incorporates copyright protection technology that is
protected by U.S. patents and other intellectual property rights
of Rovi Corporation. Use of this copyright protection technology
must be authorized by Rovi Corporation, and is intended for home
and other limited viewing uses only unless otherwise authorized
by Rovi Corporation. Reverse engineering and disassembly are
prohibited.
Disclaimer
Cisco Systems, Inc. assumes no responsibility for errors or omissions
that may appear in this guide. We reserve the right to change
this guide at any time without notice.
20081121 FCC Standard
21