Compliance Information - Cisco PDS3241 Installation Manual

Compliance Information

United States FCC Compliance
This device has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against such interference in
a residential installation. This equipment generates,
uses, and can radiate radio frequency energy. If not
installed and used in accordance with the
instructions, it may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
OFF and ON, the user is encouraged to try to
correct the interference by one or more of the
following measures:
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
diff erent from that to which the receiver is connected.
• Consult the service provider or an experienced
radio/television technician for help.
Any changes or modifications not expressly
approved by Cisco Systems, Inc., could void the
user's authority to operate the equipment.
The information shown in the FCC Declaration
of Conformity paragraph below is a requirement
of the FCC and is intended to supply you with
information regarding the FCC approval of this
device. The phone numbers listed are for FCC-
related questions only and not intended for
questions regarding the connection or operation
for this device. Please contact your service provider
for any questions you may have regarding the
operation or installation of this device.
FCC Declaration of Conformity
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
1) the device may not cause harmful interference,
and 2) the device must accept any interference
received, including interference that may cause
undesired operation.
Cisco PDS3241 Set-Top
Model PDS3241
Manufactured by: Cisco Systems, Inc.
5030 Sugarloaf Parkway
Lawrenceville, Georgia 30044 USA
26
Disclaimer
Cisco Systems, Inc. assumes no responsibility for
errors or omissions that may appear in this manual.
We reserve the right to change this manual at any
time without notice.
E362186