Remote Pairing - Python 5206P Owner's Manual

after 72 hours, if the remote control is not used during this period. Just
press any button on the remote to resume system monitoring. Power
Save 2 is for maximum battery life and monitors the system only while
the remote start is active.
Caution: Alarm trigger messages are not received while the remote
start is off.
When set to ON the remote wakes up every few seconds to listen for
pages from the system. When set to OFF the remote does not wake
up to receive remote start or alarm trigger pages.
Note: When OFF, responses will only be received when a command
is performed with the remote.

Remote Pairing

When pairing a new remote to the system, both the vehicle and the
remote must be setup. The following instructions step you through the
pairing process.
Prepare the vehicle system for pairing:
Open at least one of the vehicle's doors.
1.
Turn the ignition to the ON position.
2.
Within 5 seconds press and release the Control button on the
3.
Control Center once.
Within 5 seconds, press and hold the Control button. The status
4.
LED begins flashing in a sequence of single flashes and the siren
chirps once to confirm the system is ready for remote pairing.
Release the Control button and proceed below.
5.
Prepare the remote control for pairing:
Now that the vehicle has been setup for pairing, the remote must now
be setup.
22 © 2012 Directed. All rights reserved.