KTM 950 SUPERMOTO 2007 Owner's Manual page 71

»
MAINTENANCE WORK ON CHASSIS AND ENGINE
70
Remove the drain plug [5] from the oil tank and allow the oil to drain into a vessel. Remove
the screws [6] and tilt the connector [7] to the side.
6
7
5
6
Carefully pull the oil screen [8] out of the oil tank.
Thoroughly clean the drain plugs, the cover and both oil screens. Clean all rubber seal rings
8
and check for damage. Replace if necessary.
Mount the oil drain plug on the engine with a new seal ring and tighten to 20 Nm.
Slide the oil screen [9] into the guides in the oil pump housing with the TOP mark facing
up. Make sure the form ring is in place and mount the cap [3]. Tighten the screws to
3
10 Nm.
9