KTM 950 SUPERMOTO 2007 Owner's Manual page 64

MAINTENANCE WORK ON CHASSIS AND ENGINE
5
Remove the seat and screw [5]. Close the fuel taps and fuel line. Slightly pull the tank towards
the back, lift about 10 cm (4 in) in the front and slide it under the tank a little bit to hold
it in this position.
Remove the bleeder screw [6] and the radiator cap.
To completely bleed the cooling system, the motorcycle must be raised approx. 50 cm
(20 in) in the front.
6
»
Add cooling liquid until it runs out of the vent
holes without bubbles and immediately mount
the screw to prevent air from entering the
radiator.
Completely fill the radiator with cooling liq-
uid. Mount the radiator cap and move the
motorcycle into a horizontal position again.
Fill the compensating tank with cooling liq-
uid until it reaches a level between the MIN
and MAX mark. Close the compensating tank.
Mount the tank and M8 screw to 25 Nm.
Mount the fuel line and tank trim. Tighten
the M6 screws to 6 Nm.
63