Advertisement
Ideal Installation Locations
In the attic
On railings
To a Wall
1. Using the multi-directional base as
a template, mark the four mounting
screw locations on the wall.
2. Drill a hole in the wall at each marked
location.
3. Thread the anchors into each mounting hole.
4. While holding the mounting base against the wall, thread
a screw through each round hole in the base, anchor in the
wall, and tighten the screws.
To a Mast
1. Place the multi-directional base so that the curved bottom
rests firmly against the mast.
2. Place one U-bolt around the mast and
align the ends with the corresponding
holes on the bottom of the antenna
base.
3. Insert the ends of the U-bolt through
the holes and attach a wing nut with
spring washer to each end of the
U-bolt.
4. Repeat steps 2 and 3 for the other
U-bolt.
5. Tighten the wing nuts to secure the
base to the mast.
On a grille
On an outdoor wall
Under eaves
3
Advertisement
