Pentax K-5 II Operating Manual page 88

en
::r
0
0
~
Press the four-way controller ( ~)
and use the four-way controller
( _.. T) to select [Auto], [Off],
[Low], [Medium], [High] or
[Custom].
Auto
Applies Noise Reduction at optimally calculated levels
throughout ISO range. (default setting)
Off Does not apply Noise Reduction at any ISO setting.
Low/Medium/ Applies Noise Reduction at constant chosen level
High throughout ISO range.
Custom
Applies Noise Reduction at user-defined levels for each ISO setting.
Press the
OK
button.
If you select [Auto], [Off], [Low], [Medium], or [High], proceed to Step 7.
Use the four-way controller ( _.. T) to select [Setting] and
press the four-way controller (
~
).
The screen to set the noise reduction level according to the sensitivity appears.
Use the four-way controller ( _.. T)
to select a sensitivity value and use
the four-way controller (
~
...,. ) to set
the level of noise reduction which is
applied to the selected sensitivity.
Turn the rear e-dial
(~~~--)to
display the
[High-ISO NR 2] screen.
Press the
®
button to reset the setting of
the selected sensitivity value.
High-150 NR
ISO 80
ISO 100
ISO 200
ISO 400
ISO 800
ISO 1600
ISO 3200
1
150P.'!!I
NR~
150P.'!!I
NR~
150P.'!!I
NR~
1 5 0 -
NRr::.
1 5 0 -
NRr::::J:..-
1 5 0 -
NRr::::J:..-
@Reset
The sensitivity values displayed vary according to the [1. EV Steps] and [2.
Sensitivity Steps] settings made in the
[C
Custom Setting 1] menu.
6
Press the
MENU
button.
The screen that was displayed in Step 2 appears again.
1
Press the
MENU
button twice.
The camera is ready to take a picture.