To Exit The Learn Routine; On-Board Dual Stage Shock Sensor - Viper 330V Installation Manual

N N O O T T E E : : If the Unlock learn was unsuccessful, the Unlock procedure can be repeated
by using the LOCK learn procedure, except that at step 4 press and release the Valet
button TWICE. (The LED will flash in groups of two flashes.)

to exit the learn routine:

Do one of the following:
Turn the ignition on.
No activity for longer than 15 seconds.
Press the Valet

on-board dual stage shock sensor

There is a dual-stage shock sensor inside the control module. Adjustments are made via
the rotary control as indicated above. Since the shock sensor does not work well when
mounted firmly to metal, we recommend against screwing down the control module. The
full trigger of the onboard shock sensor reports zone 2. See Table of Zones.
N N O O T T E E : : When adjusting the sensor, it must be in the same mounting location that it will
be after the install is completed. Adjusting the sensor and then relocating the module
requires readjustment.
© 2005 directed electronics, inc.
button too many times.
®
Less Sensitive
More Sensitive
®
25