Viper 330V Installation Manual page 19

Car security
Hide thumbs Also See for 330V:
Table of Contents

Advertisement

vehicles operate this way. If this is the case connect the RED wire to the passenger
unlock motor wire. When testing this wire be sure that it shows 12V (+) ONLY when
the unlock button on the factory transmitter is pressed the second time to unlock the
passenger doors. If the factory keyless entry system unlocks all of the doors at the
same time, it is recommended that the H2/7 YELLOW/BLACK wire be used for dis-
arm defeat input.
N N O O T T E E : : The H2/3 wire connection is not required if using H2/7 YELLOW/BLACK as a
disarm defeat wire.
H H 2 2 / / 4 4 B B L L U U E E d d i i s s a a r r m m i i n n p p u u t t : : Connect the BLUE wire to a wire that changes state when the
doors are unlocked using the factory keyless entry transmitter. If the factory transmitter
unlocks the driver's door first, the BLUE wire must be connected to the wire that changes
state when the driver's door is unlocked by itself. In this case, find the driver's door
unlock motor wire. In most vehicle's this wire can be found in the driver's kick panel.
N N O O T T E E : : Some vehicles (some of the Honda, GM and Ford) have long door lock puls-
es. These long pulses may interfere with the disarm function of this system when unlock-
ing all doors using the factory OEM remote. Use the supplied door unlock pulse
adapter for these vehicles. Refer to the diagram below.
UNLOCK MOTOR
WIRE
BLUE/WHITE
H H 2 2 / / 5 5 G G R R A A Y Y t t r r u u n n k k r r e e l l e e a a s s e e / / s s e e n n s s o o r r s s h h u u n n t t i i n n p p u u t t : : This input is used to bypass the sensor
inputs when the trunk is opened using the factory keyless entry system or trunk release
relay while armed. When the system receives a (+) input on this wire, zones 1, 2 and
4 are bypassed for 3-seconds. If during that 3-seconds, ground is applied to the H1/6
© 2005 directed electronics, inc.
DOOR UNLOCK
PULSE ADAPTER
0.47 mF
POLARIZED
CAP 25V
OR
HIGHER
DIODE
+
6.2 MΩ
RESISTOR
(BLUE-RED-
GREEN-SILVER
OR GOLD)
-
WHITE/BLUE
BLACK/WHITE
CONTROL MODULE
BLUE - DISARM WIRE
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents