Memory Switches - Epson TM-P60 Technical Reference Manual

DIP switch
Handshake
DTR/DSR
RTS/CTS
DSW 1 is fixed to OFF.
Note:
Serial communication setting is assigned to MemorySwitch (baud rate, parity). See the table " Customize
values" (page 2-12) for details.
3. After set the DIP switch, attach the DIP switch cover.

2.5.3 Memory Switches

This printer has a set of software switches called "Memory switches" . The memory switch set
has "Msw 8," "Customize value," "Serial communication condition."
The "Memory switch setting utility" can change the Memory switch set to ON or OFF as shown
in the table below:
Note:
When you use this printer with RS-232C interface, you should adjust the "serial communication setting"
(see the table " Serial communication" (page 2-12).)
The Memory switch can be changed by either one of two methods:
• Memory switch setting utility
• Control by an ESC/POS command
Settings of the memory switch are stored in the NV memory; therefore, even if the printer is turned off, the
settings are maintained. Excessive use of this function may destroy the NV memory. As a guideline, do
not use this function more than 10 times a day.
When you use OPOS or APD, generally you don't need to adjust memory switch because OPOS or APD
are able to set these items automatically.
Memory Switch 8
SW Function
1 Status notice *1
2 Beeper tone when the battery is not
charged
3 Beeper tone when this printer can't
connect to any access point
4 Beeper tone when roll paper is out
5 Beeper tone when an error occurs
6 ~ 8 Reserved
* : Default setting
Rev. D
DSW1 DSW2 DSW3
OFF ON OFF
OFF OFF ON
On
Transmit s*
Beeps *
Beeps *
Beeps *
Beeps *
-
TM-P60 Technical Reference Guide
DSW4
ON
OFF
Off
Doesn't transmit
Doesn't beep
Doesn't beep
Doesn't beep
Doesn't beep
Fixed to Off *
Setup 2-11