Table 6 Twinax Command Interpreter Commands - IBM 6400 Operation Manual

Commands
Preface each of the commands in the
following list with a single logical-not
character as shown in this document by the
"¬" character.
Table 6 Gives an explanation of all the
available commands.

Table 6 Twinax Command Interpreter Commands

COMMAND ACTION
¬ONN
¬OFF
¬HEX
Multi–Platform Interface Feature Operation Guide
Enable the command interpreter. Ignored if already
on.
Disable the command interpreter - Default, power up
state. Ignored if already off.
Pack valid Hexadecimal characters two to a byte and
send to the printer. Invalid Hexadecimal characters will
be skipped - all SNA commands will be passed out.
Terminate Hex mode by sending an at sign "@".
twinax command interpreter
41