Table 2 Sample Configuration Printout (Coax) - IBM 6400 Operation Manual

Table 2 Sample Configuration Printout (Coax)

SW1-1 IBM EMULATION SELECTED
=>> 0 3287
1 3262
SW1-2 Character Set Selected
=>> 0 UNITED STATES
1 UNITED KINGDOM
SW1-3 DEFAULT MPP
=>> 0 132
1 NONE
SW1-4 DEFAULT MPL
=>> 0 NONE
1 66
SW1-6 SW1-5
=>> 0 0
0 1
1 0
1 1
SW1-7 PRINTER TYPE
=>> 0 6400-PRINTRONIX
1 6400-EPSON
SW1-8 PRINTER EMULATION (6400-PRINTRONIX)
=>> 0 P-SERIES COMPATIBLE
1 SERIAL MATRIX
SW2-1 DEFAULT IGP SFCC
=>> 0 ^ CARET (5Eh, 94d)
1 ~ TILDE (7Eh, 126d)
SW2-2 AUTO FORM FEED
=>> 0 ENABLE AFTER OPERATOR INITIATED LOCAL COPY
1 DISABLE AFTER OPERATOR INITIATED LOCAL COPY
SW2-3 PAPER ERROR REPORTING
=>> 0 NEVER REPORT PAPER ERRORS
1 REPORT PAPER ERRORS
SW2-4 MULTIPLEXER TIMEOUT
=>> 0 SHORT (15 SECONDS)
1 LONG (45 SECONDS)
If you are replacing an existing Printronix P-
Series printer, SW1-7 and SW 1-8 should be
set to the Open (Off) state. This will provide
compatibility with existing jobs.
Also, if you will be port switching, you should
set the SW1-7 and SW1-8 to be compatible
with the alternate host. See page 12 for
more information. If you set SW1-7 to 6400
Printronix (Open), you must set SW1-8. If
you set SW1-7 to 6400-Epson (Closed), you
do not need to set SW1-8 and you can
leave SW1-8 to the factory default.
Multi–Platform Interface Feature Operation Guide
IGP OPTIONS
NO IGP INSTALLED
IGP-PGL INSTALLED*
IGP-VGL INSTALLED**
RESERVED
note
configuring MPI
7