Table of Contents
Advertisement
Chapter 16. Writing a program to control autoinstall of
programs
Considerations common to all user-replaceable programs
Note that the comments contained in Chapter 5, "General notes about
user-replaceable programs," on page 435 apply to this chapter.
This chapter describes the user-replaceable program that controls the automatic
installation of programs, mapsets, and partitionsets.
Note: In this chapter, the term "program autoinstall" is used to mean autoinstall of
The chapter is divided into the following sections:
1. "Autoinstalling programs—preliminary considerations"
2. "Benefits of autoinstalling programs" on page 581
3. "Requirements for program autoinstall" on page 582
4. "The autoinstall control program at INSTALL" on page 583
5. "The sample autoinstall control program for programs, DFHPGADX" on page
Autoinstalling programs—preliminary considerations
As well as terminals and APPC connections, you can autoinstall:
v User programs
v Mapsets
v Partitionsets.
If the autoinstall program function is enabled, and an implicit or explicit load request
is issued for a previously undefined program, mapset, or partitionset, CICS
dynamically creates a definition, and installs and catalogs it, as appropriate. An
implicit or explicit load occurs when:
v CICS starts a transaction.
v An application program issues one of the following commands:
v A program abend occurs, and CICS transfers control to the program named on
© Copyright IBM Corp. 1977, 2011
all three program types (program, mapset, and partitionset) unless otherwise
specified.
586.
– EXEC CICS LINK—see "Autoinstalling programs invoked by EXEC CICS
LINK commands" on page 580
– EXEC CICS XCTL
– EXEC CICS LOAD
– EXEC CICS ENABLE (for a global user exit, or task-related user exit,
program)
– EXEC CICS RECEIVE or SEND MAP
– EXEC CICS SEND PARTNSET
– EXEC CICS RECEIVE PARTN
– A dynamic COBOL call
an EXEC CICS HANDLE ABEND command.
579
Advertisement
Chapters
Table of Contents
