Projecting; Selecting The Input Signal; Adjusting The Image - Panasonic PT-RZ475U Operating Instructions Manual

Projecting

Check the external device connections (x page 30) and the power cord connection (x page 35), and turn on the projector (x page 36)
to start projecting. Select the video for projection, and adjust appearance of the projected image.

Selecting the input signal

Select an input signal.
1) Press the input selection (<COMPUTER>, <DVI-I>, <VIDEO>, <DIGITAL LINK>, <HDMI>) buttons on the
remote control or the <INPUT SELECT> button on the control panel.
f The image of the signal being input in the selected terminal is projected.
Attention
f Images may not be projected properly depending on the external device, or the blu-ray disc or DVD disc, to be played back.
Set the [PICTURE] menu → [SYSTEM SELECTOR].
f Confirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu →
[ASPECT].

Adjusting the image

1) Adjust the projection angle.
f Install the projector on a flat surface and parallel to the screen so that the projected screen is rectangular.
f If the screen is tilted downward, extend the adjustable feet and adjust the projection screen so that the projected screen is rectangular.
f Refer to "Adjusting adjustable feet" (x page 29) for details.
2) Press the <FUNC3> button on the remote control.
f The focus adjustment screen is displayed.
3) Press asqw to adjust the focus.
Note
f It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
f When there is trapezoidal distortion, execute the [POSITION] menu → [KEYSTONE].
f When the projection position needs to be adjusted, do so following the procedure described in "Adjusting the projection position"
(x page 41).
Chapter 3 Basic Operations — Projecting
ENGLISH - 39