Installing Backup And Restore Software - IBM 160 GB DLTV4 Installation And User Manual

If your server does not recognize the tape drive after startup or if you receive
startup errors, run the Configuration/Setup Utility program as described in the
documentation that comes with your server. If all the LEDs on the front panel of the
tape drive blink in unison, there is a problem with the tape drive. Press the Unload
button on the right side of the tape drive front panel to eject any tape that might be
inserted and to reset the tape drive. If the problem remains, turn the server off and
on. If the problem remains, see "Troubleshooting" on page 14 for more information.

Installing backup and restore software

Use the backup and restore function that is provided with your server, or install a
separate backup and restore application for the server operating system.
v If you are using a separate backup and restore application, follow the installation
v If you are using the backup and restore support that your operating system
instructions that come with the application.
provides and the operating system requests a device driver, insert the
Documentation CD and look in the device driver folder. If the required device
driver is not included on the Documentation CD, go to www.ibm.com/pc/support/
site.wss/document.do?lndocid=TAPE-FILES and search for 39M5659 or DLTV4
for a list of new and updated device drivers.
Chapter 2. Installing the tape drive
7