Completing The Installation; Turning On The Server; Updating The Configuration - IBM 160 GB DLTV4 Installation And User Manual

1. Connect the SATA data cable to the system board or SATA adapter on the
2. Connect either the SATA power cable to the SATA power connector or the tape

Completing the installation

Check your work before you close the server:
1. Make sure that the power cable and SATA cable are securely connected, and
2. Replace the server cover and secure it in place.
3. Reconnect the cables to the server and then reconnect the power cords to the

Turning on the server

Turn on all the attached devices; then, turn on the server. The tape drive performs a
power-on self-test (POST) within 15 seconds.

Updating the configuration

In most servers, the Configuration/Setup Utility program automatically recognizes
the new tape drive. However, you might have to provide information about system
changes after you restart the server.
6
160/320 GB DLTV4 Tape Drive: Installation and User's Guide
server, and then connect it to the tape drive.
SATA power
cable
Attention:
a. Do not connect both the SATA power cable and the tape drive power cable.
If you connect both power cables to the tape drive, you might damage the
tape drive.
b. Do not force the tape drive power cable into the tape drive power connector.
If the tape drive power cable is upside down and you force the connection,
you might damage the tape drive.
drive power cable connector to the four-pin connector on the tape drive as
shown in the previous illustration.
that the cables are neatly routed.
server.
SATA data cable
Tape drive power cable